Pressure Systems 9022 Manual de usuario descargar pdf (Pagina 107)

Pressure Systems, Inc. NetScanner™ System (9016, 9021, & 9022) User’s Manual

www.PressureSystems.com

3 - 77

RE-BOOT MODULE (UDP/IP Command ‘psireboot’)

Purpose: To unconditionally “reboot” a specified module.

Command “psireboot ethadr”

where ethadr is the Ethernet address

of the specified module in the

following special hex-digit format

‘xx-xx-xx-xx-xx-xx’

Response

none (module reboots)

Description: When a module receives this broadcast command, (by continuously monitoring port

7000) it responds by immediately restarting its firmware. The result is essentially the

same as a power-up restart, in that any TCP/IP connection is lost, and the module

returns to its normal startup state. The host must wait long enough for the re-boot

process to be completed before it can again request a connection to the module.

Example:

! Re-boot a specified module on the network.

“psireboot 00-E0-8D-00-00-01”

Response:

(None)

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 193 194

Sin comentarios

Pressure Systems 9022 Manual de usuario Pagina 107